5000 PSI BOP Hydraulic Control System Wireline Pressure Control Equipment

5000 PSI BOP Hydraulic Control System Wireline Pressure Control Equipment

Wireline Pressure Control Equipment BOP Hydraulic Control System

I. Introduction:

BOP Hydraulic Control System is a surface pressure control equipment using on slickline operation to seal off the wire, and the sealing of the wire according the rubber seal packing. The BOP plunger of the blowout system is used for the sealing of the downhole pressure after the wire break.The seal packing are both available with manual and hydraulic control methods.

II.Maintenance:

1 maintain After operation, completely disassemble the BOP and clean it. Check whether all sealing surfaces and sealing parts are intact with naked eyes. Found damaged parts should be replaced in time.

2. Regular replacement of gate seal:

3. Regular replacement of balance valve seal:

III.matters need attention:

1. Check the internal and external seals and O-rings of the ram in time and replace them in time;

2. After each maintenance, performance test (gate sealing test) should be done;

3. Conduct strength test and sealing test regularly.

Welcome to contact us at any time.

5000 PSI Double Ram BOP

BOP Wireline Pressure Control Equipment

10000 PSI Wireline Pressure Control Equipment

5000 PSI BOP Hydraulic Control System Wireline Pressure Control Equipment Images